What are the recommended UWTerminalX settings for the Vela IF820?

To use UWTerminalX with the Vela IF820 it is recommended to use the following settings

• Tick DTR
• Untick BREAK
• Untick Localecho
• Untick linemode
• baud rate 115200
• parity none
• stop bits 1
• data bits 8
• handshaking none
• Terminal select  CR
• use UART 1

On booting the Vela IF820, if all is good you should see the EZ-Serial boot message something like this, note the @E indicates an event, in this case boot.

@E,0074,BOOT,E=01040808,S=03010000,P=0104,H=23,C=00,A=E0984030FB5D,F=EZ-Serial-CYBT_243053_02 V1.4.8.8 Jun  9 2023 10:03:25

To confirm two way communications send/type the following followed by carriage return

/ping

To which the module should respond with somthing like the following, note the @R indicates a response, in this case to the /ping command. The /PING,0000 indicates the command was successful

@R,001D,/PING,0000,R=0000007F,F=F218